Table of Contents
Advertisement
x
During manual start-up, the motor rotates at maximum speed and the pressure
control is not activated, therefore the pump reaches its maximum pressure.
x
Ensure there is water inside the pump unit, otherwise the pump seal will be
destroyed.
5.5
MANUAL START/STOP
It is possible to manually stop the pump by pressing the START/STOP button: in this situation the display
alternatively shows the writing STOP.
During STOP status the module is not operative unless the anti-lock mode is activated (TAB parameters -
installation parameters 5.3.4). The word "abl" will be displayed if the condition is active.
START/STOP sequence of buttons
x
CHAPTER 6 - SIGNALS, ALARM STATUS AND ERRORS
6.1 HISTORY (SAVED)
Key sequence
Press ESC for 5 seconds
Key sequence
Press MODE to scroll the error log
Key sequence
Press STOP to see the hour and the date of the event
(when the clock has been set correctly)
6.2 SIGNAL TABLE
MESS
DISPLAY
System
INIT
signal
System re-initiation
REIN
signal
Inhibitor
INIB
intervention signal
Reset configuration
RPC
Press the START/STOP button again to exit the STOP condition
DESCRIPTION
initiation
The condition occurs when the
system is first started-up or after a
prolonged power failure
The condition occurs when a
short power failure takes place
This is an operative condition
generated
command which closes entry to
the inhibitors. (NO – NC)
Page 18 of 30
by
an
external
18 - GB -
Push the STOP button
Press ESC
Press MODE
Press STOP
ACTION
Wait for a change in status
Check
the
external
command
(i.e.
switch,
pressure gauge).
inhibitor
float,
45
Advertisement
Table of Contents
