Pentair Pool Products C Series Installation Instructions

Download this manual

READ AND FOLLOW ALL INSTRUCTIONS

SECTION I.

SECTION II.

SECTION III.

SECTION IV.

Before installing this product, read and follow all warning notices and instructions accompanying this pump.

Failure to follow safety warnings and instructions can result in severe injury, death, or property damage.

Call (800) 831-7133 for additional free copies of these instructions.

Attention Installer.

This manual contains important information about the installation, operation and safe use of this

product. This information should be given to the owner/operator of this equipment.

This pool pump must be installed by a licensed or certified electrician or a qualified pool

serviceman in accordance with the National Electrical Code and all applicable local codes and

ordinances. Improper installation will create an electrical hazard which could result in death or

serious injury to pool users, installers, or others due to electrical shock, and may also cause

damage to property.

Always disconnect power to the pool pump at the circuit breaker before servicing the pump.

Failure to do so could result in death or serious injury to serviceman, pool users or others due to

electric shock.

Pentair Pool Products

1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151

10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400

Rev. D 7-17-02

C SERIES

Installation Instructions

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Table of Contents

MOTOR REMOVAL. ............................................................................................ 2

MOTOR INSTALLATION PROCEDURES ......................................................... 2

PARTS LIST C SERIES PUMPS. ......................................................................... 3

C SERIES PUMP CURVES .................................................................................. 4

Important Notice

Risk of electrical shock or electrocution.

™

PUMP

WARNING

P/N 075277

Page 1 MOTOR REMOVAL..................... 2 SECTION II. MOTOR INSTALLATION PROCEDURES ............2 SECTION III. PARTS LIST C SERIES PUMPS................3 SECTION IV. C SERIES PUMP CURVES .................. 4 WARNING Before installing this product, read and follow all warning notices and instructions accompanying this pump.
Page 2 4. Press seal spring member (16) on motor shaft with carbon face towards ceramic seal member. Avoid cutting rubber parts on shaft. C SERIES PUMP DIMENSIONS 5. Line up keyways and push impeller (15) on motor shaft up to shoulder. Insert square key (21) in place.
Page 3 All motor subassemblies are single phase 60 Hertz. 6 in. All motor subassemblies are 50 Hertz 380/415v, 3 Phase. Suction Notes: Flange All brass C Series parts will retrofit older cast iron models. 5 in. Suction Standard flange not included with pump. Volute Flange...
Page 4 SECTION IV. C SERIES PUMP CURVES FLOW RATE IN GPM FLOW RATE IN GPM SAVE THESE INSTRUCTIONS. Pentair Pool Products 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 P/N 075277 Rev.