Preparing The System To Remove And Replace Internal Parts - IBM 9006-22C Installing And Configuring

interval
The time to turn on the identify LED in seconds. The default value is 15. This means that the LED is on
for 15 seconds and then turns off for 15 seconds. A value of zero (0) turns off the LED. A value of
force turns on the LED and leaves it on until turned off.
To run the command remotely over the LAN, enter the following chassis identify command:
ipmitool -I lanplus -H <hostname> -U <username> -P <password> chassis identify <interval>
Preparing the 5104-22C, 9006-22C, or 9006-22P system to remove and
replace internal parts
To prepare the system to remove and replace internal parts, complete the steps in this procedure.
Procedure
1. Complete the prerequisite tasks. For instructions, see "Before you begin servicing the 5104-22C,
9006-12P, 9006-22C, or 9006-22P system" on page 99.
2. Identify the part and the system that you will be working on. For instructions, see "Identifying the
5104-22C, 9006-12P, 9006-22C, or 9006-22P system that contains the part to replace" on page 102.
3. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
• When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock
when using or working on electrical equipment.
• If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds. If at any point in this service process you move away from the system,
it is important to again discharge yourself by touching an unpainted metal surface for at least
5 seconds before you continue with the service process.
4. Stop the system. For instructions, see "Stopping the 5104-22C, 9006-12P, 9006-22C, or 9006-22P
system" on page 110.
5. Disconnect the power source from the system by unplugging the system. For instructions, see
"Disconnecting the power cords from an 5104-22C, 9006-22C, or 9006-22P system" on page 119.
Note: The system might be equipped with redundant power supply. Before you continue with this
procedure, ensure that all power to your system is disconnected.
(L003)
or
Common procedures for servicing or installing features in the 5104-22C, 9006-22C, or 9006-22P system 105