Installing A Drive On Module - IBM 9006-22C Installing And Configuring

The rescan-scsi-bus tool is available in the sg3_utils package; install the package by using the
following command:
yum install sg3_utils
You can also refer to: Adding a Storage Device or Path (https://access.redhat.com/
documentation/en-US/Red_Hat_Enterprise_Linux/7/html/Storage_Administration_Guide/logical-
unit-add-remove.html).
9. Load or restore data from your backup media.
Installing a drive on module in the 9006-22C system
Learn how to install a drive on module (DOM) in the IBM Power System LC922 (9006-22P) system.
Before you begin
Power off the system and place it in the service position. For instructions, see "Preparing the 5104-22C,
9006-22C, or 9006-22P system to remove and replace internal parts" on page 105.
About this task
You can plug SATA drive on module (DOM) drives directly into the system backplane. Up to two SATA DOM
drives can be installed. Use the two orange SATA connectors.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
• When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock
when using or working on electrical equipment.
• If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds. If at any point in this service process you move away from the system,
it is important to again discharge yourself by touching an unpainted metal surface for at least
5 seconds before you continue with the service process.
2. Install the DOM into the system backplane, in positions (A), as shown in Figure 20 on page 25.
Depending on the DOM model, you might also have to plug in a small power cord for the DOM. Ensure
that you plug in the connectors properly.
24 Power Systems: Installing and configuring the IBM Power System LC922 (9006-22P)