IBM 9006-22C Installing And Configuring page 39

Figure 20. Installing a DOM
3. Prepare the system for operation. For instructions, see "Preparing the 5104-22C, 9006-22C, or
9006-22P system for operation after you remove and replace internal parts" on page 107.
4. For a non-RAID drive, configure the installed drive for your environment. If the drive is part of a RAID
configuration, skip this step, the drive is detected and configured when inserted.
After you insert the new drive, you need to rescan for the device.
Ubuntu Linux operating system
To run the rescan-scsi-bus command in the Ubuntu Linux operating system, log in to the
system as the root user, and run the following command:
rescan-scsi-bus
The rescan-scsi-bus tool is available in the scsitools package; install the package by using
the following command:
sudo apt-get install scsitools
Red Hat Enterprise Linux (RHEL) version 7.2
To run the rescan command in the REHL version 7.2 operating system, log in to the system as the
root user, and run the following command:
rescan-scsi-bus.sh -a
Installing and configuring your system and system features 25