Idv26Prl Porcelain Liner Panels - Kingsman Marquis IDV26 Installation Instructions Manual

IDV26PRL
IDV26PL Parts List:
-1 Back Panel
-1 Right Side Panel
-1Left Side Panel
To Remove:
1. Remove Log Supports. Remove
the [5] screws in the firebox top
holding the Baffle in place.
2. Remove Back Panel. Unscrew and
remove the Back Panel. Slide and
tilt to remove. NOTE: If you will be
installing a porcelain Back Liner,
unscrew Back Panel Air Deflector
and install on porcelain Back Liner.
3. Remove Side Panels (if present).
Remove screw. Tilt and slide Side
Panels out of fireplace.
To Install
:
1. Install Side Panels. If you are using Side
Panels, install them first. Tilt and slide
Side Panels into place. Secure with screw
in side of firebox.
2. Install Back Panel. Ensure that Back
Panel Air Deflector is in place on Back
Panel (See Illustration). Place Back Panel
up against the back of the Firebox and
reinstall the [2] Screws in firebox top.
Then slide lower Liner Retainer Clip
(located on bottom of firebox behind
burner) up to bottom of Back Panel &
tighten.
3. Replace Baffle. Replace Baffle and
proceed with Log or Rock/Glass Tray
setup.
Note: Warping and Discoloration of Porcelain or
Painted Metal Liners Is Not Covered Under
Warranty.
Both Porcelain and Painted Metal Liners may discolor
and warp during normal operation of your appliance.
This is normal, and not considered a defect
- Porcelain Liner Panels-
Side Panel
Side Panel
Back Panel
.
Air Deflector
Back Panel
Back Panel Air Deflector
Baffle
Log Supports
Top
Back Panel
20