Suzuki CELERIO Series Owner's Manual page 90

Low Tire Pressure Warning Light
(if equipped)
When the TPMS system is normal and
drop of the tire pressure is not detected,
the light will turn off after it is lit for 2 sec-
onds when the ignition switch is turned to
the "ON" position.
This light illuminates or blinks when the
ignition switch is turned to the "ON" posi-
tion in the condition below.
When the low tire pressure warning light is
lit, one or more of your tires is significantly
under-inflated. This system does not oper-
ate when the speed is less than approxi-
mately 35 km/h.
When this light is lit, cool down the tire
temperature.
Then check the tire pressure and adjust it
to the value specified in the tire information
label.
After the tire pressure is adjusted, push the
TPMS reset switch for 3 seconds or more
to initialize the system. When initialization
is set, the light will blink at a faster speed
for 5 seconds and then turn off.
When the system detects a TPMS mal-
function, this light will blink at a slower
speed for about 75 seconds and then
remain continuously illuminated.
This sequence will be repeated after the
ignition switch is turned to the "ON" posi-
tion as long as the malfunction exists.
For details, refer to "TPMS Reset Switch"
in the "OPERATING YOUR VEHICLE"
section.
52D305
BEFORE DRIVING
WARNING
• Air pressures should be checked
when the tires are cold or you may
get inaccurate readings.
• Check the inflation pressure from
time to time while inflating the tire
gradually, until the specified pres-
sure is obtained.
• The low tire pressure may be
caused by flat tire. Park the vehicle
at a safe place as soon as possible
and check your tires.
• Make sure that all 4 tires are at the
specified tire pressure and the tire
temperature is lowered, before
making adjustment.
• Check the tire pressure at least
once a month.
• Do not push the TPMS reset switch
while driving. The proper condition
of the tire pressure cannot be
detected and the TPMS system
does not operate properly.
2-72
84MM6-01E