Suzuki CELERIO Series Owner's Manual page 324

6) Hold the bottle (2) with bottom upwards
and pump the bottle to fill the entire bot-
tle contents (sealant) into the tire.
Thereafter pull off the filler hose and
firmly screw the valve insert into the tire
valve again. If the valve insert is dirty or
lost, use the enclosed spare valve
insert.
10 min. Max.
(10)
(9)
required
air pressure
(1)
(8)
84MM00805
7) Screw the air hose (9) of the compres-
sor (1) to the tire valve (8). Fit the
power plug (10) to the accessory
socket. Start the engine. Switch on the
compressor. Inflate the tire to the
required air pressure.
WARNING
Do not stand by the tire, when inflat-
ing. It can burst.
NOTICE
Do not operate the compressor for
longer 10 minutes without cease. It
can cause overheating of the com-
pressor.
If the air pressure cannot be reached the
required air pressure within 5 minutes, the
tire may be severely damaged. In this
case, the flat tire repair kit cannot provide
the necessary seal. Consult a SUZUKI
dealer or a roadside assistance service.
NOTE:
If over inflated, deflate air by loosening the
screw of the air hose.
8) Make a short drive immediately after
inflating to the required air pressure.
Drive carefully with a maximum speed
of 80 km/h (50 mph).
EMERGENCY SERVICE
9) Affix the enclosed speed restriction
label in the driver's field of view, and
carry on driving carefully to the nearest
SUZUKI dealer or a tire repair shop.
WARNING
Do not affix the speed restriction
label to the air bag cover. Also do not
affix it to the warning light indicator
or to the speedometer.
10)After 10 minutes or 5 km (3 mile) run-
ning, check the tire pressure with the
pressure gauge of the compressor. If
the air pressure is indicated more than
130 kPa (1.3 bar), the emergency
repair is completed. But, if the air pres-
sure is indicated less than the required
air pressure, correct the tire pressure to
the required air pressure. If the tire
84MM6-01E
63J351
8-8