Suzuki CELERIO Series Owner's Manual page 167

OTHER CONTROLS AND EQUIPMENT
Air intake selector (4)
(g) (f)
76MH0A089
This selector is used to select the following
modes.
Fresh Air (f)
When this mode is selected, the indicator
light will go off and outside air is used.
Recirculated Air (g)
When this mode is selected, the indicator
light will come on, outside air is shut out
and inside air is recirculated. This mode is
suitable when driving through dusty or pol-
luted air such as in a tunnel, or when
attempting to quickly cool down the inte-
rior.
"FRESH AIR" and "RECIRCULATED AIR"
are switched alternately each time the air
intake selector is pushed.
NOTE:
If you select "RECIRCULATED AIR" for an
extended period of time, the air in the vehi-
cle can become contaminated. Therefore,
you should occasionally select "FRESH
AIR".
5-17
System Operating Instructions
Natural ventilation
Select "VENTILATION" and "FRESH AIR",
the temperature selector to the desired
temperature position, and the blower
speed selector to "OFF". Fresh air will flow
through the vehicle during driving.
Forced ventilation
The control settings are the same as for
natural ventilation except you set the
blower speed selector to a position other
than "OFF".
Normal heating (using outside air)
Select "HEAT" and "FRESH AIR", the tem-
perature selector to the desired tempera-
ture position and the blower speed selector
to the desired blower speed position. Set-
ting the blower speed selector to a higher
blower speed position increases heating
efficiency.
Quick heating (using recirculated air)
The control settings are the same as for
normal heating except you select "RECIR-
CULATED AIR". If you use this heating
method for an extended period of time, the
air in the vehicle can become contami-
nated and the windows can become misty.
Therefore, use this method only for quick
heating and change to the normal heating
method as soon as possible.
Head cooled/Feet warmed heating
Select "BI-LEVEL" and "FRESH AIR", the
temperature selector to the desired tem-
perature position, and the blower speed
selector to the desired blower speed posi-
tion. Unless the temperature selector is in
the fully COLD position or fully HOT posi-
tion, the air that comes out of the center
and side outlets will be cooler than the air
that comes out of the floor outlets.
Defrosting/Feet warmed heating
Select "HEAT & DEFROST" and "FRESH
AIR", the temperature selector to the
desired temperature position, and the
blower speed selector to HIGH. When the
windshield has become clear, set the
blower speed selector to the desired
blower speed position.
Defrosting
Select "DEFROST" and "FRESH AIR", the
temperature selector to the desired tem-
perature position (higher temperature pro-
vides more efficient defrosting), and the
blower speed selector to HIGH. When the
windshield has become clear, set the
blower speed selector to the desired
blower speed position.
84MM6-01E