Suzuki CELERIO Series Owner's Manual page 300

EXAMPLE
For maintenance-free battery (cap-less
type), you need not add water. For tradi-
tional type battery, which has water filler
caps, the level of the battery solution must
be kept between the "UPPER" and the
"LOWER" level lines at all times. If the
level is found to be below the "LOWER"
level line, add distilled water to the
"UPPER" level line. You should periodically
check the battery, battery terminals, and
battery hold-down bracket for corrosion.
Remove corrosion using a stiff brush and
ammonia mixed with water, or baking soda
mixed with water. After removing corro-
sion, rinse with clean water.
If your vehicle is not going to be driven for
a month or longer, disconnect the cable
from the negative terminal of the battery to
help prevent discharge.
EXAMPLE (1)
(3)
(2)
(4)
54G118
To remove the battery:
1) Disconnect the negative cable (1).
2) Disconnect the positive cable (2).
3) Remove the bracket bolt (3) and
remove the bracket (4).
4) Remove the battery.
To install the battery:
1) Install the battery in the reverse order of
removal.
2) Tighten the bracket bolt and battery
cables securely.
NOTE:
When the battery is disconnected, some of
the vehicle's function will be initialized and/
or deactivated.
These function are required to reset after
the battery is reconnected.
INSPECTION AND MAINTENANCE
WARNING
Batteries contain toxic substances
including sulfuric acid and lead. They
could have potential negative conse-
quences for the environment and
human health. Used battery must be
disposed or recycled according to
the local law and must not be dis-
carded with ordinary
waste. Make sure not to tip over the
(3)
battery when you remove it from the
vehicle. Otherwise,
could run out and you might get
84MM00701
injury.
(Battery label)
Pb
(5) Crossed-out wheeled bin symbol
(6) Chemical symbol of "Pb"
household
sulfuric acid
(5)
(6)
51KM042
7-36
84MM6-01E