Brakes - Suzuki CELERIO Series Owner's Manual

EXAMPLE
(3)
(3)
(2)
(1)
(2)
(1) FULL HOT
(2) LOW HOT
(3) The lowest point = Fluid level
8) Add just enough specified fluid through
the dipstick hole to fill the transaxle oil
to the proper level.
NOTICE
After checking or adding oil, be sure
to insert the dipstick securely.
Changing Oil
Since special procedures, materials, and
tools are required to change the CVT oil, it
is recommended that you trust this job to
your authorized SUZUKI dealer.

Brakes

Brake Fluid
(1)
54G317
Check the brake fluid level by looking at
the reservoir in the engine compartment.
Check that the fluid level is between the
"MAX" and "MIN" lines. If the brake fluid
level is near the "MIN" line, fill it up to the
"MAX" line with SAE J1703 or DOT3 brake
fluid.
INSPECTION AND MAINTENANCE
WARNING
Failure to follow the guidelines below
can result in personal injury or seri-
ous damage to the brake system.
• If the brake fluid in the reservoir
drops below a certain level, the
brake warning light on the instru-
ment panel will come on (the
engine must be running with the
parking brake fully disengaged).
Should the light come on, immedi-
ately ask your SUZUKI dealer to
inspect the brake system.
• A rapid fluid loss indicates a leak in
the brake system which should be
inspected by your SUZUKI dealer
immediately.
• Do not use any fluid other than SAE
J1703 or DOT3 brake fluid. Do not
76MH0A110
use reclaimed fluid or fluid that has
been stored in old or open contain-
ers. It is essential that foreign parti-
cles and other liquids are kept out
of the brake fluid reservoir.
CAUTION
Brake fluid can harm your eyes and
damage painted surfaces. Use cau-
tion when refilling the reservoir.
7-30
84MM6-01E