Status:questionable[:Event] - Keysight U3606A Programmer's Reference Manual

11 STATus Subsystem

STATus:QUEStionable[:EVENt]?

STATus:QUEStionable[:EVENt]?
Syntax
STATus:QUEStionable[:EVENt]?
This command queries the event register for the Questionable Data
register group and returns a decimal value which corresponds to the
binary- weighted sum of all bits set in the condition register. For example,
if bit 1 (decimal value = 2) and bit 9 (decimal value = 512) are set, this
command will return the decimal value "+514".
N O T E
Remarks
• An event register latches the various events from the condition register.
• Once a bit is set, it remains set until cleared by reading the event
• The STATus:PRESet, SYSTem:PRESet, *RST, and *PSC commands
Example
& STAT:QUES?
$ +2568
See also
"STATus:PRESet" on page 288
"SYSTem:PRESet" on page 301
292
This is a read-only register and the bits are cleared when you read the
register. For more information on the bit definitions of the Questionable
Data register and the SCPI status diagram see the
System" on page
There is no buffering in this register; while an event bit is set,
subsequent events corresponding to that bit are ignored.
register.
have no effect on this register.
12.
This command reads the event register for the
Questionable Data register group.
U3606A Programmer's Reference
"SCPI Status