Carrier AERO 39MN Installation, Start-Up And Service Instructions Manual page 64

SCREW THE BASE RAIL OF THE TOP UNIT
TO THE TOP FRAMERAIL OF THE BOTTOM UNIT
NOTE: Two turning plenums are needed to make
the stacked configuration. Screw the baserail of
the top unit to the top framerail of the bottom unit.
Fig. 31 — Securing Fan and Coil Sections Together
Fig. 32 — Stacked Turning Plenum
LOCK NUT
LOCK WASHER
FLAT WASHER
STUD
a39-4248
TURNING PLENUM
(FIELD STACKED)
63
2-IN. GASKET
FACTORY-INSTALLED
AROUND PERIMETER
OF FRAME FLUSH TO
OUTSIDE EDGE
a39-4345