Removing The Front Cover From A Stand-Alone 8286-41A System - IBM PCIe3 x8 SAS RAID internal adapter 6 Gb Manual

A
Figure 21. Removing the front cover

Removing the front cover from a stand-alone 8286-41A system

Use this procedure to remove the cover from a stand-alone 8286-41A system so that you can access
components or perform service.
To remove the front cover, complete the following steps:
1. Open the front door.
2. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
3. Pull the blue tab (A) to open the bezel door.
4. Push the blue latch (B) located above the USB ports, in the direction shown on the latch and then pull
the front cover away from the system.
38
PCIe3 x8 SAS RAID internal adapter 6 Gb