Table of Contents
Advertisement
Figure 37. Installing the service access cover
Installing the service access cover on a stand-alone 8286-41A system
Use this procedure to install the service access cover on a stand-alone 8286-41A system.
To install the service access cover on a stand-alone system, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Slide the cover (B) on to the system unit.
3. Close the latch release (A) by pushing it in the direction shown.
51
Common procedures for removing or replacing the PCIe3 x8 SAS RAID internal adapter 6 Gb
Advertisement
Table of Contents
