IBM PCIe3 x8 SAS RAID internal adapter 6 Gb Manual page 23

Figure 4. Replacing the PCIe3 x8 SAS RAID internal adapter 6 Gb in slot P1-C14
13. Leave the front SAS cable disconnected from the disk drive backplane until directed to connect it.
14. Remove the filler from slot location P1-C15.
15. Connect the new, longer front SAS cable to the SAS RAID internal adapter connector P1 before you
install the adapter. Push the connector in until the latch clicks.
16. Route the front SAS cable into position while you are lowering the SAS RAID adapter into the slot.
17. Complete the installation of the SAS RAID adapter by fully seating it. Ensure that the adapter is
installed on locating pin (A). Press the top-center edge of the card down to firmly seat it into the
system backplane connector. See Figure 5 on page 6.
18. Push the blue handles (B) in the direction that is shown. See Figure 5 on page 6.
19. Push the cable retention bracket (C) in the direction that is shown. See Figure 5 on page 6.
PCIe3 x8 SAS RAID internal adapter 6 Gb
5