4. Pull the disconnected end of the cables out of the guide block on the side of the system chassis, as
shown in Figure 11.
Figure 11. Removing the front SAS cable from the guide block
5. Lift the cable retention bracket (A) in the direction that is shown in Figure 12 on page 14.
6. Lift the blue handles (B) in the direction that is shown in Figure 12 on page 14.
7. Lift the SAS RAID internal adapter out of the slot with the front SAS cables still connected to the
adapter. Ensure that the front SAS cables do not get caught on any components while you are lifting
the SAS RAID internal adapter out of the slot.
PCIe3 x8 SAS RAID internal adapter 6 Gb
13