Prepare Your System; Prepare Your System X Or Xseries Server; Preparing The System X Or Xseries Hardware; Update The System X Or Xseries Firmware And Configure The Server - IBM iSCSI Host Bus Adapter Manual

Table of Contents

Prepare your system

If this is the first iSCSI Host Bus Adapter (HBA) to be installed in your xSeries or blade server, follow the

appropriate xSeries or blade server procedure before you install the iSCSI HBA.

"Prepare your blade server" on page 10

Prepare your System x or xSeries server

You might need to perform assembly, firmware update, and other preparation tasks to ensure your server

is ready for a successful installation. Find instructions in the following sections to accomplish these tasks.

Locate information to assemble your server hardware.

The first step in preparing a System x or xSeries server is to assemble the hardware. This might include

installing the keyboard, mouse, display, additional processors, additional memory and can also include

options that may be required for the iSCSI Host Bus Adapter (HBA) solution, such as RSA II and the

iSCSI HBA. Refer to System x or xSeries options documentation for details on how to install the System x

or xSeries components.

Important: Do not connect any cables until instructed to do so. Connecting cables at the wrong point in

the installation process may cause problems later.

Perform the updates on all System x or xSeries servers to be attached.

Update the System x or xSeries server with the latest version of system basic input/output system

(BIOS), Baseboard Management Controller firmware and system processor firmware.

Remember: You might be directed by the installation process on the iSCSI install read me first Web site to

download the updates and return later to this document to apply the updates. If you have not already

downloaded the firmware updates see "Download System x or xSeries BIOS firmware" on page 25.

Preform these updates on all System x or xSeries servers that are to be attached.

Refer to the file named README you printed during the BIOS update download procedure. Use the

README file instructions along with the steps below to perform the update. The README file contains

any changes necessary to the following instructions. Follow the directions in the README file wherever

differences occur.

If you have not downloaded the BIOS update or printed the readme file see "Download System x or

xSeries BIOS firmware" on page 25.

Perform the following steps on the server:

1. Plug the System x or xSeries server ac power cords into a power source. Refer to System x or xSeries

documentation to complete this step.

Table of Contents