IBM PCIe3 x8 SAS RAID internal adapter 6 Gb Manual page 22

5. Lift the cable retention bracket (A) in the direction that is shown in Figure 3.
6. Lift the blue handles (B) in the direction that is shown in Figure 3.
7. Lift the SAS RAID internal adapter out of the slot with the front SAS cables still connected to the
adapter. Ensure that the front SAS cables do not get caught on any components while you are lifting
the SAS RAID internal adapter out of the slot.
B
Figure 3. Removing the SAS RAID internal adapter in slot P1-C14
8. Remove the bottom front SAS cable from the P1 connector on the SAS RAID internal adapter.
9. Reinstall the SAS RAID internal adapter in slot P1-C14. Route the front SAS cable into position while
you are lowering the PCIe3 x8 SAS RAID internal adapter 6 Gb into the slot.
10. Complete the installation of the PCIe3 x8 SAS RAID internal adapter 6 Gb by fully seating it. Ensure
that the adapter is installed on locating pin (A). Press the top-center edge of the card down to firmly
seat it into the system backplane connector, as shown in Figure 4 on page 5.
11. Push the blue handles (B) in the direction that is shown in Figure 4 on page 5.
12. Push the cable retention bracket (C) in the direction that is shown in Figure 4 on page 5.
4
PCIe3 x8 SAS RAID internal adapter 6 Gb
A