Self-Diagnosis; Temperature Probe - Faema E92/A Compact Manual

English
11.

Self-diagnosis

In case of malfunction, the machine will display (25) warning messages with audio signals.
Error E1
The following message will be displayed:
boiler overpressure
This means that the boiler has exceeded the maximum possible pressure
due to a malfunction in the heating apparatus. The electricity to the
water heating elements in the boiler is cut off.
In this case, switch off the machine by pressing the general switch (1)
and contact the authorized servicing department.
Error E4
The following message will be displayed:

temperature probe

open circuit E4
This means that the temperature sensor does not send the signals to
the electronic card. The electricity to the water heating elements in the
boiler is cut off.
In this case, switch off the machine by pressing the general switch (1)
and contact the authorized servicing department.
Resin regeneration
The following message will be displayed:
regenerate softener
then press:
The softener resin must be regenerated. Follow the softener instructions.
Upon completion of the operation, press the key
seconds and the message on the display will be cancelled.
N.B.: During the display of this message the machine’s functions are
not blocked.
The message will not be displayed when the machine is connected to
an automatic softener.
E1
>>>
(33) for a few
4 4 4
Error E2
The following message will be displayed:
check water supply
This means that there is no water supply to the boiler.
In this case, switch off the machine by pressing the general switch (1)
and check the position of the water supply tap.
If it is closed, open it and switch on the machine.
If the message is displayed again, contact the authorized servicing
department.
Cleaning the milk circuit
The following two messages will be displayed alternately:
clean the
milk circuit
then press >>>
Clean the milk circuit following the procedure described in Paragraph
"Cleaning - Cleaning the Cappuccino Maker”.
Upon completion, press the key
message will be cancelled.
The messages are displayed after 2.5 ÷ 3 hours after the last milk
dispensing, except when the milk time is set to the value "00.0".
N.B.: During the display of this message the machine’s functions are
not blocked.
English
E2
(33) for a few seconds and the
4 4 4