Electrical connection
6.3 Terminal box
You can find additional information here:
● Bringing cables into the terminal box 1XB... with cable gland (Page 89)
● Connecting cables with cable lugs (Page 90)
● Connecting cables without cable lugs (Page 91)
6.3.6
Terminal box 1XB7750
Figure 6-7
The connecting cables are introduced into the 1XB7750 terminal box through the cable glands
with threaded holes 8 x M72 x 2 and 3 x M25 x 1.5. The cable glands are not included in the
standard scope of supply.
You can find additional information here:
● Bringing cables into the terminal box 1XB... with cable gland (Page 89)
● Connecting cables with cable lugs (Page 90)
● Connecting cables without cable lugs (Page 91)
6.3.7
Rotating the terminal box
Depending on the terminal box and version, you can rotate the terminal box through ±90° in
accordance with the connection direction. The implementation on the other motor side is
possible only with the support of the Service Center (Page 171). If you want to rotate a terminal
box not listed below, then also contact the Service Center.
80
Terminal box 1XB7750
SIMOTICS FD 1LN1
Operating Instructions 01/2019