Sub-Zero Built-In Refrigeration Use & Care Information Manual page 18

S U B - Z E R O
I C E | WAT E R
D I S P E N S E R L I G H T S
For Models 685 and 695, there are three
lighting states than can be cycled by pressing
the LIGHT key pad on the glasswell.
During water or ice dispensing, all lights will
illuminate until dispensing is complete, then
lights will return to their previous state.
D I S P E N S E R W AT E R G R I L L E
For Models 685 and 695, a water grille at the
base of the glasswell will catch and evaporate
small spills. Because there is no drain in this
area, do not pour water into the water grille.
To clean the area, remove the water grille by
pressing the front left corner of the grille and
lifting it out.
18
B U I LT- I N U S E & C A R E
D I S P E N S I N G M O D E L S
All lights OFF
All lights ON (blue key pad and white
glasswell)
Key pad lights ON only
L O C K
For Models 685 and 695, the lock feature is
used to prevent unintended ice and water
dispensing. When the dispenser is locked, all
key pads on the glasswell are deactivated to
allow cleaning or to prevent small children
from using the dispenser.
To activate the lock feature, hold down the
LIGHT key pad on the glasswell until the key
pad lights flash once and the red LOCK icon is
illuminated (approximately five seconds). The
lights will remain in the state they were in
before the lock feature was activated.
To deactivate the lock feature, hold down the
LIGHT key pad until the key pad lights flash
once and the red LOCK icon is no longer illu-
minated (approximately five seconds). The
lights will remain in the state they were in
before the lock feature was deactivated.
I C E D I S P E N S I N G
Models 685 and 695 have a feature that limits
the maximum amount of ice that is dispensed
each time the ICE key pad on the glasswell is
pressed.
To dispense ice, hold down the ICE key pad for
approximately two seconds. The dispenser will
meter out ice for about two seconds, collect
the ice directly above the glass, then drop the
ice into the glass. If less ice is desired, hold the
ICE key pad down for less than two seconds. If
more ice is desired, hold the ICE key pad down
until the dispensing cycle repeats.
IMPORTANT NOTE: Be sure that dispenser
key pads are clean and dry when pressed to
avoid problems with the dispenser operation.