Sub-Zero Built-In Refrigeration Use & Care Information Manual page 14

S U B - Z E R O
R E F R I G E R ATO R
H I G H H U M I D I T Y C R I S P E R D R A W E R
To remove your high humidity crisper drawer,
pull open until the drawer stops. Now raise the
front of the drawer and pull it out. To reinstall,
insert the drawer into the tracks with the front
A C C E S S O R I E S
end raised. Refer to the illustration below.
Some units also have other storage drawers,
Optional acces-
which can be removed in a similar manner.
sories are available
through your
Sub-Zero dealer. To
A D J U S TA B L E G L A S S S H E L V E S
obtain local dealer
information, visit
Be sure to read and understand the following
the Locator section
instructions before removing or adjusting
of our website,
shelves. To remove or adjust shelves, first tilt
subzero.com.
the shelf up at the front, then lift it up and
out of the tracks on the rear wall of the
refrigerator. Refer to the illustration below.
If the door is limited to a 90-degree opening,
you'll need to clear the door shelves in order
to remove a shelf. Lift and pivot the end of the
shelf nearest the door upward, and remove.
To replace a shelf, insert it in the tracks at the
rear of the refrigerator with the front of the
shelf raised slightly. As you push the shelf in,
lower the front of the shelf until it locks into
position.
IMPORTANT NOTE: Always be careful in
handling glass shelves to prevent breaking or
scratching the interior.
High humidity crisper drawer
removal
14
B U I LT- I N U S E & C A R E
S T O R A G E
Adjustable glass shelf removal
Glass shelves should warm to room
temperature before immersing in warm
water.
R O L L - O U T U T I L I T Y B A S K E T
The utility basket rolls in and out so that you
can get to small containers and food items
easily. To remove the basket, pull it out, lift up
on the front, then out. Refer to the illustration
below.
To replace the basket, insert the roller into its
tracks with the front of the basket raised, and
push in.
If the door is limited to a 90-degree opening,
you'll need to remove the entire utility basket
and shelf as one unit in order to clear the door
shelves. To do this, place one hand, palm up,
under the basket and lift it out of the support
tracks. Pivot the end of the basket assembly
nearest the door upward, and remove.
The utility basket is available as an option on
Models 601RG, 611G and 650G. Contact your
Sub-Zero dealer for details.
Roll-out utility basket removal