Air Filter Inspection; Air Filter Cleaning - Honda F300 Owner's Manual

4MV488000.book 36 ページ ２０１６年３月２日 水曜日 午後１２時３６分
SERVICING YOUR TILLER

AIR FILTER INSPECTION

1. Unscrew the wing nut, and remove
the air cleaner cover. Check the air
filter elements to be sure they are
clean and in good condition.
2. If the air filter elements are dirty,
clean them as described on page
37. Replace the air filter elements
if they are damaged.
3. Reinstall the air cleaner cover,
and tighten the wing nut securely.
After mating face seats, please
carry out 1-turn (360 degrees)
revolution of the tightening of
wing nut.
Operating the engine without an air filter, or with a damaged air filter,
will allow dirt to enter the engine, causing rapid engine wear. This type
of damage is not covered by the warranty.

AIR FILTER CLEANING

A dirty air filter will restrict air flow to the carburetor, reducing engine
performance. If you operate the tiller in very dusty areas, clean the air
filter more frequently than specified in the Maintenance Schedule.
1. Remove the wing nut and air cleaner cover.
2. Remove the wing nut and the grommet which holds the air filter elements.
3. Hold the air filter elements with the air cleaner undercover, remove
both of them together.
Be careful not to drop any dust in the air cleaner elbow intake hole.
36
AIR CLEANER COVER
WING NUT
GROMMET
PAPER
ELEMENT
FOAM
ELEMENT
ELBOW PACKING
AIR CLEANER
ELBOW INTAKE
HOLE
AIR CLEANER UNDER COVER