Handling Tips - Honda F300 Owner's Manual

4MV488000.book 24 ページ ２０１６年３月２日 水曜日 午後１２時３６分
OPERATION

HANDLING TIPS

• Adjust the handlebar height to a comfortable position (waist height
for normal tilling).
• The drag bar should always be used when tilling. It enables you to
compensate for the hardness of the soil. The ideal height of the drag
bar will depend on the type of soil being tilled and soil conditions at
the time of tilling. In general, however, the drag bar should be
adjusted so that the tiller is tilted slightly backward.
• If the machine jerks forward while tilling, press down on the
handlebars. This will cause the drag bar to dig more deeply into the
soil.
• If tines dig in but the machine will not move forward, move the
handlebars from side to side.
• Stop the tines before crossing gravel drives, walks, or roads. Stay
alert for hidden hazards or traffic.
• Stop the engine immediately if the tiller vibrates abnormally. Check
the tiller for damage or loose parts, and repair or replace them
before using the tiller again. Vibration is usually a sign of trouble.
• Raise the tiller immediately if it overturns. Stop the engine, look over
carefully; inspect the engine for oil or fluid leaks, check the tightness
of nuts and bolts, and operation of control parts such as the
handlebar and control levers. If you decide that the tiller is capable
of driving and safety, restart the engine. Consult your dealer, if the
engine does not start again.
Break-in operation: 20 minutes
Move the throttle lever to SLOW position and run the engine for 10
minutes, then move to FAST position and run for 10 minutes more.
24