Storage Precautions; Removal From Storage - Honda F300 Owner's Manual

4MV488000.book 50 ページ ２０１６年３月２日 水曜日 午後１２時３６分
STORAGE

STORAGE PRECAUTIONS

If your tiller will be stored with gasoline in the fuel tank and carburetor,
it is important to reduce the hazard of gasoline vapor ignition. Select a
well ventilated storage area away from any appliance that operates
with a flame, such as a furnace, water heater, or clothes dryer. Also
avoid any area with a spark-producing electric motor, or where power
tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Unless all fuel has been drained from the fuel tank, leave the fuel valve
in the OFF position to reduce the possibility of fuel leakage.
Place the tiller on a level surface. Tilting can cause fuel or oil leakage.
With the engine and exhaust system cool, cover the tiller to keep out
dust. A hot engine and exhaust system can ignite or melt some
materials. Do not use a plastic sheet as a dust cover. A nonporous
cover will trap moisture around the tiller, promoting rust and corrosion.

REMOVAL FROM STORAGE

Check your tiller as described in the BEFORE OPERATION chapter of
this manual (see page 14).
If the fuel was drained during storage preparation, fill the tank with
fresh gasoline. If you keep a container of gasoline for refueling, be sure
that it contains only fresh gasoline. Gasoline oxidizes and deteriorates
over time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine may smoke briefly at start-up. This is normal.
50