Honda F300 Owner's Manual page 39

4MV488000.book 37 ページ ２０１６年３月２日 水曜日 午後１２時３６分
4. Remove the elbow packing and clean it if it is to be reused.
5. Separate the air filter elements, carefully check them for holes or
tears and replace if necessary.
6. Clean both filter elements if they are to be reused.
Foam element:
Clean in warm soapy water, rinse and allow to dry thoroughly, or
clean with a high flash point solvent and allow to dry.
Dip the element in clean engine oil and squeeze out all the excess oil.
Excess oil will restrict air flow through the foam element and may
cause the exhaust to smoke when the engine starts.
Clean
Paper element:
Tap the filter element several times to remove dirt. Never try to
brush off dirt; brushing will force dirt into the fibers.
7. Install the foam element onto the paper element.
SERVICING YOUR TILLER
Squeeze and Dry
Do not twist.
Squeeze
Dip in Oil
Do not twist.
37