Maguire Products VBD-150 Installation Operation & Maintenance page 50

VBD® - Vacuum Dryer®
Servicing / Removing the Vacuum Chamber
Turn OFF Main Power
Lower the Vacuum Chamber by switching down the
Vacuum Chamber Lift Switch.
Turn OFF Air Supply on Dryer
Disconnect Air Lines
Lower the Retention Hopper sealing collar located
at the bottom of the Vacuum Chamber. The
sealing collar is attached to the base of the
Vacuum Chamber with magnets. Detach the
sealing collar by pulling down.
Lift the Slider Lock located to the left of the
Vacuum Chamber. While holding the Slider Lock
up, pull the Vacuum Chamber slider out. Release
the Slider Lock, which will rest on top of the
opened slider.
With the Vacuum Chamber
slider fully slid out, the
Vacuum Chamber can be
cleaned or removed.
If the Vacuum Chamber is removed, use caution.
Do not damage the upper seal or the lower frame.
The Vacuum Chamber can be rested on the base
frame.
50
Rev. August 31, 2016 – VBD-150
Maguire Products, Inc.