Leica M 10 Instructions Manual page 213

The camera shutter refuses to trip�
– Picture data is currently being transferred to the memory card
and the back-up memory is full.
– The capacity of the memory card is exhausted and the back-up
memory is full.
Delete pictures you no longer require before taking new ones.
– No memory card has been inserted and the back-up memory is
full.
– The memory card is write-protected or defective.
Switch the write protection off, or insert a different memory
card.
– Image numbering has run out.
Reset Image numbering.
– The sensor has overheated.
Give the camera a chance to cool down.
I cannot save the picture�
– Is a memory card inserted?
– The capacity of the memory card is exhausted.
Delete pictures you no longer require before taking new ones.
The monitor image is too dark or too bright�
– When viewing the monitor image from oblique angles it is always
more difficult to see.
If it is too light or too dark although you are looking at the
monitor perpendicularly: Set a different brightness or use the
external electronic viewfinder available as an accessory.
The picture I have just taken is not shown in the monitor
– Is the function turned on (when the camera is set
Auto Review
to picture mode)?
I cannot display the picture�
– Is a memory card inserted?
– The memory card does not contain any data.
The date and time displays show incorrect values or are blank�
– The camera has not been used for a long period, particularly if
the battery has been removed.
Insert a fully charged battery.
Set the date and time.
EN
209