Agregation To A Tractor - Farmet DISKOMAT 3 Operating Manual

Manual
DISKOMAT 3 | 3,5
 Aggregation of the machine with the tractor is to be performed on a flat and hardened surface.

When working on slopes, observe the lowest slope grade of the set TRACTOR - MACHINE.

Before starting the tractor motor, check whether no person or animal is in the working space of the set and
push the warning sound signal.

The operator is responsible for the safety and all damage caused by the operation of the tractor and the
connected machine.

The operator is obliged to adhere to the technical and safety regulations of the machine determined by the
producer when working.
 The operator is obliged to retract the working bodies of the machine from the ground when turning at the
headland.
 The operator is obliged to observe the prescribed working depths and speeds stated in the manual in Tabl.
2/p. 4 when

The operator is obliged to lower the machine to the ground and secure the set against movement before
leaving the tractor cabin.

3.1 AGREGATION TO A TRACTOR


The machine can be connected only to a tractor, whose curb weight is identical or higher than the overall
weight of the connected machine.

The machine operator must observe all generally valid regulations of work safety, health protection, fire
safety, and environmental protection.

The operator may connect the machine exclusively to a tractor that is equipped with a rear three-point
suspension and a functional undamaged hydraulic system.
 The table of requirements for the towing means for work with the machine:
(5)
Requirement for the tractor engine power for disc plough-harrow
(5)
Requirement for the tractor engine power for disc plough-harrow
(6)
Requirement for the tractor's TPS

Connect the machine using the TPS suspension to the lower arms of the rear TPS of the tractor, secure the
TPS arms using pins against disconnecting.

Connect the third point of the tractor only to the circular hole both for work and transport.

The machine aggregated with the tractor changes the distribution of the weight to the individual axles of
the tractor. The weight of the front axle is reduced and therefore the controllability gets worse. It also
affects braking properties.
When connecting, no persons may stay in the space between the tractor and the
machine.
(7)
Spacing of the lower suspension joints (measured
at the joint axes)
(8
)
of the hole of the lower suspension joints for
the machine suspension pivots
10 │ 19
DISKOMAT 3
DISKOMAT 3,5
105-158 kW
120-180 kW
1010±1,5 mm
37,5 mm