Preparations For Use; Visual Inspection; Shipping And Storage Conditions; Requirements - Siemens SIMOTICS CONNECT 400 Operating Instructions Manual

Preparations for use

4.1

Visual inspection

After mounting the motor, visually inspect the connectivity module for any damage.
Contact customer service (Page 47) if you identify any damage.
4.2

Shipping and storage conditions

Transporting hazardous goods
The product is classified as a hazardous product according to UN 3091. The product contains
lithium-metal batteries. The batteries contain approximately 2.6 g of lithium. When the product
is transported, it is not permissible that the battery connector is in contact with the electronics
module.
Carefully comply with the regulations that are applicable for transport.
NOTICE
Damage to the connectivity module due to external influences
The connectivity module is mounted onto the motor in the factory before the motor is shipped.
During transport, storage and when the motor is operated, the connectivity module can be
damaged due to external influences.
Do not damage the connectivity module while the motor is being transported, stored and
operated. It is not permissible that the connectivity module is subject to mechanical loads and
stress.
4.3

Requirements

Mobile device for the "SIDRIVE IQ Config" application
To set up the connectivity module, install the "SIDRIVE IQ Config" application on a mobile
device. The mobile device must satisfy the following requirements:
● "Android" operating system with Version V5.0 or later
● Functioning Internet connection
SIMOTICS CONNECT 400
Operating Instructions, 07/2019
WARNING
4
13