Clevo W130HU Service Manual page 38

Disassembly
Processor Installation Procedure
Figure 8
Processor 1. Insert the CPU
Installation
IT!), and turn the release latch
2. Insert the heat sink
3. Tighten the CPU heat sink screws in the order
a. Insert the CPU.
b. Turn the release latch to-
4. Replace the component bay cover.
wards the lock symbol.
c. Insert the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 3 Screws
2 - 12 Removing and Installing a Processor
(Figure 8a), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
A
towards the lock symbol
B
at an angle of around 30° as indicated in
D
a.
A
b.
B
(Figure 8b).
Figure 8c.
, & (the order as indicated on the label and
1 2 3
c.
D
d.
2
Note:
Tighten the screws
in the order as indi-
cated on the label.
Figure 8d).
3
1