Clevo W130HU Service Manual page 34

Disassembly
Reinserting the HDD
Figure 4
1. To reinsert the HDD assembly
HDD Installation
the HDD directly down into the bay vertically
2. Press and slide the HDD assembly at the area illustrated
a. Insert the HDD di-
direction of arrows to make sure the HDD fits securely into the connector.
rectly down into the
3. Press down on the rubber case
bay vertically.
b. Press and slide the screws.
HDD assembly at the
4. Replace the component bay cover
area illustrated 2
c. Press down on the
rubber case

Hard Disk Handling
Do not press down on the
center off the hard disk as
this area houses the hard
disk drive motor.

1. HDD Assembly
2 - 8 Removing and Installing the Hard Disk Drive
hold it carefully at the four corners between your thumb and forefinger and Insert
6 1
to ensure the assembly is properly seated before replacing the cover and
3
(page 2 -
a.
1
b.
2
2
)
(Figure 1a .
(do not press on the center area - see sidebar) the
2
6).).
c.
3
3