Cisco ASA 5506-X Configuration Manual page 404

Default Settings
•
Default Settings
Table 18-1
Table 18-1
Parameters
Management IP address
Gateway
Username
Password
Note The default management IP address on the ASA is 192.168.1.1/24.
Configuring the ASA IPS module
This section describes how to configure the ASA IPS module.
•
•
•
•
•
•
•
•
Task Flow for the ASA IPS Module
Configuring the ASA IPS module is a process that includes configuration of the IPS security policy on
the ASA IPS module and then configuration of the ASA to send traffic to the ASA IPS module. To
configure the ASA IPS module, perform the following steps:
Cable the ASA IPS management interface. See
Step 1
page
Cisco ASA Series Firewall CLI Configuration Guide
18-6
ASA 5585-X—See
–
http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/qa_c67-617018.
html
You cannot change the software type installed on the module; if you purchase an ASA IPS module,
you cannot later install other software on it.
lists the default settings for the ASA IPS module.
Default Network Parameters
Task Flow for the ASA IPS Module, page 18-6
Connecting the ASA IPS Management Interface, page 18-7
Sessioning to the Module from the ASA, page 18-10
Configuring Basic IPS Module Network Settings, page 18-11
(ASA 5512-X through ASA 5555-X) Booting the Software Module, page 18-10
Configuring the Security Policy on the ASA IPS Module, page 18-12
Assigning Virtual Sensors to a Security Context, page 18-13
Diverting Traffic to the ASA IPS module, page 18-15
18-7.
Default
192.168.1.2/24
192.168.1.1/24 (the default ASA management IP address)
cisco
cisco
Connecting the ASA IPS Management Interface,
Chapter 18 ASA IPS Module