Cisco ASA 5506-X Configuration Manual page 366

Monitoring the ASA FirePOWER Module
For example:
asasfr-boot> system install http://upgrades.example.com/packages/asasfr-sys-5.3.1-54.pkg
When the boot completes, log in as admin with the password Sourcefire.
Step 10
Complete the system configuration as prompted.
You must first read and accept the end user license agreement (EULA). Then change the admin
password, then configure the management address and DNS settings, as prompted. You can configure
both IPv4 and IPv6 management addresses.
Identify the FireSIGHT Management Center appliance that will manage this device using the configure
Step 11
manager add command.
You come up with a registration key, which you will then use in FireSIGHT Management Center when
you add the device to its inventory. The following example shows the simple case. When there is a NAT
boundary, the command is different; see
page
> configure manager add 10.89.133.202 123456
Manager successfully configured.
Step 12 Log into the FireSIGHT Management Center using an HTTPS connection in a browser, using the
hostname or address entered above. For example, https://DC.example.com.
Use the Device Management (Devices > Device Management) page to add the device. For more
information, see the Managing Devices chapter in the FireSIGHT System User Guide or the online help
in FireSIGHT Management Center.
Upgrade the System Software
Use FireSIGHT Management Center to apply upgrade images to the ASA FirePOWER module. Before
applying an upgrade, ensure that the ASA is running the minimum required release for the new version;
you might need to upgrade the ASA prior to upgrading the module. For more information about applying
upgrades, see the FireSIGHT System User Guide or the online help in FireSIGHT Management Center.
If you are managing the module through ASDM, you can apply upgrades to the system software and
components using Configuration > ASA FirePOWER Configuration > Updates. Click Help on the
Updates page for more information.
Monitoring the ASA FirePOWER Module
The following topics provide guidance on monitoring the module. For ASA FirePOWER-related syslog
messages, see the syslog messages guide. ASA FirePOWER syslog messages start with message number
434001.
•
•
•
Cisco ASA Series Firewall CLI Configuration Guide
16-26
16-16.
Showing Module Status, page 16-27
Showing Module Statistics, page 16-28
Monitoring Module Connections, page 16-28
Add ASA FirePOWER to the FireSIGHT Management Center,
Chapter 16 ASA FirePOWER (SFR) Module