Cisco ASA 5506-X Configuration Manual page 389

Chapter 17 ASA CX Module
For more information, see
Guidelines for ASA CX, page 17-6
interfaces.
Before You Begin
•
•
Procedure
Step 1 Enter interface configuration mode for the physical interface you want to use for traffic-forwarding.
interface physical_interface
Example:
hostname(config)# interface gigabitethernet 0/5
Step 2 Remove any name configured for the interface. If this interface was used in any ASA configuration, that
configuration is removed. You cannot configure traffic-forwarding on a named interface.
no nameif
Step 3 Enable traffic-forwarding.
traffic-forward cxsc monitor-only
Enable the interface.
Step 4
no shutdown
Repeat for any additional interfaces.
Examples
The following example makes GigabitEthernet 0/5 a traffic-forwarding interface:
interface gigabitethernet 0/5
no nameif
traffic-forward cxsc monitor-only
no shutdown
Managing the ASA CX Module
This section includes procedures that help you manage the module.
•
•
•
•
•
Traffic-Forwarding Interface in Monitor-Only Mode, page
Be sure to configure both the ASA policy and the ASA CX to have matching modes: both in
monitor-only.
In multiple context mode, perform this procedure within each security context.
Reset the Password, page 17-20
Reload or Reset the Module, page 17-20
Shut Down the Module, page 17-20
(ASA 5512-X through ASA 5555-X) Uninstall a Software Module Image, page 17-21
(ASA 5512-X through ASA 5555-X) Session to the Module From the ASA, page 17-21
for guidelines and limitations specific to traffic-forwarding
Cisco ASA Series Firewall CLI Configuration Guide
Managing the ASA CX Module
17-3. See also
17-19