Cisco ASA 5506-X Configuration Manual page 383

Chapter 17 ASA CX Module
Note
Example:
hostname# sw-module module cxsc recover configure image
disk0:asacx-5500x-boot-9.3.1.1-112.img
Load the ASA CX boot image by entering the following command:
Step 4
hostname# sw-module module cxsc recover boot
Wait approximately 5 minutes for the ASA CX module to boot up, and then open a console session to
Step 5
the now-running ASA CX boot image. The default username is admin and the default password is
Admin123.
hostname# session cxsc console
Establishing console session with slot 1
Opening console session with module cxsc.
Connected to module cxsc. Escape character sequence is 'CTRL-SHIFT-6 then x'.
cxsc login: admin
Password: Admin123
Tip
Partition the SSD:
Step 6
asacx-boot> partition
....
Partition Successfully Completed
Perform the basic network setup using the setup command according to
Step 7
Settings, page 17-14
software image.
Step 8 Install the System Software image using the system install command:
system install [noconfirm] url
Include the noconfirm option if you do not want to respond to confirmation messages. Use an HTTP,
HTTPS, or FTP URL; if a username and password are required, you will be prompted to supply them.
When installation is complete, the system reboots, which closes the console session. Allow 10 or more
minutes for application component installation and for the ASA CX services to start. (The show module
cxsc output should show all processes as Up.)
The following command installs the asacx-sys-9.3.1.1-112.pkg system software.
asacx-boot> system install https://upgrades.example.com/packages/asacx-sys-9.3.1.1-112.pkg
Username: buffy
Password: angelforever
Verifying
Downloading
Extracting
If you get a message like "ERROR: Another service (ips) is running, only one service is allowed
to run at any time," it means that you already have a different software module configured. You
must shut it down and remove it to install a new module as described in the prerequisites section
above.
If the module boot has not competed, the session command will fail with a message about not
being able to connect over ttyS1. Wait and try again.
(do not exit the ASA CX CLI), and then return to this procedure to install the
Configure the ASA CX Module
Configure Basic ASA CX
Cisco ASA Series Firewall CLI Configuration Guide
17-13