Cisco ASA 5506-X Configuration Manual page 397

Chapter 17 ASA CX Module
Feature Name
NAT 64 support for the ASA CX module
ASA 5585-X with SSP-40 and -60 support for
the ASA CX SSP-40 and -60
Multiple context mode support for the ASA
CX module
Filtering packets captured on the ASA CX
backplane
Platform
Releases Description
ASA 9.1(2) You can now use NAT 64 in conjunction with the ASA CX
ASA CX 9.1(2) module.
We did not modify any commands.
ASA 9.1(3) ASA CX SSP-40 and -60 modules can be used with the
ASA CX 9.2(1) matching level ASA 5585-X with SSP-40 and -60.
We did not modify any commands.
ASA 9.1(3) You can now configure ASA CX service policies per
ASA CX 9.2(1) context on the ASA.
Note Although you can configure per context ASA
service policies, the ASA CX module itself
(configured in PRSM) is a single context mode
device; the context-specific traffic coming from the
ASA is checked against the common ASA CX
policy.
We did not modify any commands.
ASA 9.1(3) You can now filter packets captured on the ASA CX
ASA CX 9.2(1) backplane using the match or access-list keyword with the
capture interface asa_dataplane command.
Control traffic specific to the ASA CX module is not
affected by the access-list or match filtering; the ASA
captures all control traffic.
In multiple context mode, configure the packet capture per
context. Note that all control traffic in multiple context
mode goes only to the system execution space. Because
control traffic cannot be filtered using an access-list or
match, these options are not available in the system
execution space.
We modified the following command: capture interface
asa_dataplane.
Cisco ASA Series Firewall CLI Configuration Guide
History for the ASA CX Module
17-27