Start The Camera - Spypoint LINK-EVO Start Manual

START THE CAMERA

We strongly suggest to slow format your SD card in a
computer, even more if it has been used in another electronic
device.
1. Turn the camera ON
Use the ON/OFF switch to turn the camera ON.
2. All lights flashing - Searching for signal
operation might need to be repeated as the SPYPOINT
SIM card and services are powered by multiple
providers. The network modem will manoeuvre to
ensure strongest signal strength by searching for the
best tower available (cell network).
3. Solid blue bars - Signal strength
practice to label DBM values to a specific number of
bars.
4. Red light flashing (30 s) - Installation delay
The test light in front of the camera will flash for 30
seconds to allow the user to leave the area without being
photographed or recorded.
24
The signal search can take few minutes to
process. If only 1 blue bar is flashing, the
network test was unsuccessful. Get outside
or near a window to maximize signal
strength and restart the camera. This
Once the network test is completed, blue bars
will stabilize showing the signal strength. Note
that signal bars displayed on the camera can
differentiate of those shown on other cellular
devices as there is no industry standards and