MedeaWiz® Hydra™
.
Restore Default Settings
To set the Hydra back to the factory default Mode 1
Remove all wires from the inputs 1 – 9.
Then connect a jumper wire from Input 1 to the DMX terminal "G" on the rear panel.
Hold the Set push button pressed while applying power to the Hydra.
After power is applied, release the button.
This change will not reset the re-trigger delay or the DMX address.
Firmware Upgrade / User Programming
We may release upgraded firmware in the future. Please check
http://www.medeawiz.com/
or
follow the MedeaWiz Sprite on Facebook
for updates.
https://www.facebook.com/MedeaWiz/
Distributors may offer a service to upgrade your firmware for a small fee plus shipping.
38 |
P a g e