MedeaWiz Hydra H-9X28D User Manual page 10

MedeaWiz® Hydra™
.
Mode 13
Delayed trigger step on Input 1 and motion input. Motion has re-start delay.
Mode 13 controls one Sprite on Port 1.
It is similar to Mode 11, but with delayed triggering.
Trigger will only occur at the end of the looping file 000.
Read FAQ about Delayed Trigger at end of manual.
It has 9 trigger inputs plus an optional motion sensor input on Port 2.
Sensor trigger on PORT 2 has a user selectable delay time to wait before a new trigger.
There are no sinking outputs programmed.
When power is applied the file named 000 will loop circular continuously until a trigger event.
Inputs 1 to 9 will trigger when grounded / connected to input 0.
Any trigger below will delay until the looping file 000 ends.
A trigger on input 1 will play the next file on the SD or USB, circular, excluding file 000.
A trigger on Port 2 will play the next file on the SD or USB, circular, excluding file 000.
A trigger on input 2 will play the previous file on the SD or USB, circular, excluding file 000.
A trigger on inputs 3 to 8 will play files 001 to 006.
Mode 13 is No Interrupt
A new input trigger will be ignored while a prior triggered file is playing.
After a triggered file plays, the 000 loop file will play and is ready for a new delayed trigger.
Re-trigger delay on Port 2 is preset to 30 seconds but may be changed from 1 to 999 seconds.
Input 9 will interrupt other files and return to the 000 looping file.
Mode 15
Random file triggers on input 1 and motion input (with re-start delay), no interrupt
Mode 15 controls one Sprite on Port 1.
It has 1 trigger input plus an optional motion sensor input on Port 2.
Sensor trigger on PORT 2 has a user selectable delay time to wait before a new trigger.
There are no sinking outputs programmed.
When power is applied the file named 000 will loop circular continuously until a trigger event.
Input 1 will trigger when grounded / connected to input 0
Port 2 is set for a motion sensor input and will trigger on a +3 to +5 Volt input.
A trigger on input 1 or Port 2 will play a randomly selected file .
You may use files named 001 up to 200 on the SD or USB drive. Do not skip numbers.
Mode 15 is No Interrupt
A new input trigger will be ignored while a prior triggered file is playing.
Re-trigger delay on Port 2 is preset to 30 seconds but may be changed from 1 to 999 seconds.
The user selectable re-trigger delay on Port 2 can be used in various ways.
In a kiosk or special effect, you may want some quiet time between motion triggers.
You can also connect a jumper wire to force a trigger at intervals set by the delay time.
Find more information about Port 2 on page 28.
9 | P a g e