Table of Contents
Advertisement
MedeaWiz® Hydra™
.
Setting Re-Trigger Delay
The re-trigger delay is factory set to 30 seconds but may be changed from 1 to 999* seconds.
The delay is only for Port 2 input, primarily for using a motion sensor.
The delay does not affect inputs 1 to 9.
The delay uses the DMX address value.
There are 2 Steps to change the re-trigger delay:
1) You will enter a DMX address value equal to your desired time delay in seconds.
Please refer to Setting the DMX Address on pages 33 to 37.
2) After entering a DMX address, you must again set the operation Mode desired.
Please refer to Setting the Mode on pages 19 to 24.
The re-trigger delay on Port 2 can be used in various ways.
In a kiosk or special effect, you may want some quiet time between motion triggers.
You can also connect a jumper wire to force a trigger at intervals set by the delay time.
*Notes on delay time:
Short delay times under 5 seconds may have unpredictable trigger results.
Delay times are not exact due to variations in components.
Delay times can change slightly at different ambient temperature extremes.
A setting of 999 will be approximately 16 minutes and 39 seconds.
A setting of 17 is approximately 1 second.
Setting value / 16.6666 = seconds.
29 |
P a g e
Advertisement
Table of Contents
