Table of Contents
Advertisement
MedeaWiz® Hydra™
.
Example for two digits Mode 15
Unplug / turn off the power to the Hydra.
Remove all input wires. You can pull out the plug to disconnect them.
If any input is grounded, the Hydra will read the inputs and ignore your SET button.
Hold the Set button pressed down and turn on the power.
The yellow LED will light
Release the Set button
The Green LED will light indicating ready. You must start entry / press before 2.5 seconds.
Press and release the Set button 1 time for Digit One.
Each press / release will cause the LED to go Yellow / Green
Yellow indicates the button is down, Green that the button is up and ready to press.
After entering your Digit One:
Wait about 2.5 seconds and see the Yellow LED flash on, then back to Green
The Hydra is now ready for you to enter the Digit Two.
Press and release the Set button 5 times for Digit Two.
Each press / release will cause the LED to go Yellow / Green
After entering your Digit Two:
Wait about 2.5 seconds and see the Yellow LED flash on, then back to Green
The hydra is now ready for you to enter the Digit Three (You will do nothing)
After 2.5 seconds both LEDs are dark
Then the Green LED will flicker to indicate that your Mode is stored in memory.
23 |
P a g e
Advertisement
Table of Contents
