Use And Maintenance - Sunrise Medical Jay J3 Back Owner's Manual

JA Y 3 B AC K
The owner of this equipment is responsible for making sure that it has been set up
and adjusted by a Authorized Dealer under the advice of a healthcare professional.
It may require periodic safety and function checks or certain in-use adjustments that
can be performed by the owner, caregiver or Authorized Dealer if desired.
A. MAINTENANCE AND CLEANING
1. Proper maintenance and cleaning will improve performance and extend the
useful life of your equipment.
2. Clean your equipment regularly. This will help you find loose or worn parts and
make your equipment easier to use. You will need a mild detergent solution
and cleaning rags.
3. If discovered, have loose, worn, bent or damaged parts replaced before using
the back support.
B. CRITICAL SAFETY CHECKS
1. Fasteners:
Sunrise Medical recommends that all fasteners be checked for wear, such as loose
bolts or broken components Every 6 months. Loose fasteners should be retightened
according to the installation instructions.
2. Replacing components:
Contact your Authorized Dealer immediately to replace any components. Do not
continue to use the system after identifying loose or broken components.
C. EASY CLEANING
3
1. Back Cover
a. Remove the cover from backshell by detaching the Velcro
on the bottom of the cover.
b. Remove the foam and turn the cover inside out.
c. Zip the cover closed to avoid snagging.
d. Machine wash in warm water (50°C).
e. Drip and tumble dry in on Low Heat.
NOTE – Do not dry clean covers or use industrial washers or dryers to clean covers. Do not
steam autoclave. Do not bleach. Laundry care symbol definitions are shown (Fig. 3).
2. Back shell
a. The backshell should be wiped clean with soap and water on a regular basis to
prevent buildup of dirt and grime.
3. Positioning components
a. Remove the components one at a time, noting the placement for re-assembly.
b. Positioning components can be wiped clean with soap and water.
c. DO NOT immerse positioning components underwater.
D. REMOVAL AND REPLACEMENT
After installation/adjustment, the back can be easily removed from the wheelchair if
necessary.
1. Removal:
a. Push both release levers forward to unlock the hardware (Fig 4).
b. Once both levers are in the forward position, lift the back straight up, using the
handle located on the top of the back.
2. Proper re-attachment after removal
To re-attach the back and hardware receivers, line up the pins to the receivers.
a.
b. Push the back into place on the receivers.
c. If properly inserted, the pins will "click" into a locked position.
3. Locking Pins
The locking pins provide a safety feature which prevents the back from being
released unintentionally from the wheelchair.
a. To lock, insert the pins (A) into the mounting receivers (B).
b. Remove the pins if the quick-release capability is desired.
WARNING
®
Unzip the zipper
.
4
IV. USE AND MAINTENANCE
If you are uncertain that you have heard the lock-
ing "click", pull up on the back using the handle to
test and make sure it has been securely locked.
If you fail to heed this warnings damage to your
equipment, a fall, or loss of control may occur and
cause severe injury to the rider or others.
5
Laundry Care Symbols
Machine wash in
warm water (50° C)
Only non-chlorine
bleach, when needed
Drip dry
Do not iron
Do not dry clean
WARNING
3
4
103721 Rev. F