Maintenance And Cleaning - Sunrise Medical JAY ZIP Back Owner's Manual

ENGLISH
MAINTENANCE
• Sunrise recommends that all fasteners be checked
for wear, such as loose bolts or broken components
every 6 months.
• Loose fasteners should be tightened according to the
installation instructions.
• All fasteners should be tightened to torque
specifications as stated in the hardware installation
section.
• Contact your authorized Sunrise Medical supplier
immediately to replace any broken components.
WARNING
• Do not continue to use the system after identifying
loose or broken components.
NOTE: A wrench has been included with the back for
your convenience.
EASY CLEANING (Fig.2.0)
CAUTION
When disassembling the back for cleaning, note the
position of the Velcro® Lumbar Positioning Components
for correct reassembly.
To clean back cover
Remove cover by detaching Velcro.
Detach cover from back shell.
Locate zipper on bottom of the cover and unzip.
Remove foam with inner cover and turn cover inside out.
Zip cover closed to avoid snagging.
Machine wash in warm water (60°C).
Drip or tumble dry on low heat.
CAUTION
• Do not dry clean covers or use industrial washers
and dryers to clean cover.
• Do not steam autoclave.
• Do not bleach.
• Reinsert the foam with inner cover into the cover.
NOTE: The base has two layers of foam. When
reinserting the foam, ensure that the thinner, firmer, light
grey foam is facing the shell and the softer foam is facing
the user.
Once the foam is secured inside the cover, zip cover
closed.
To clean back shell and Inner Cover
Shell and inner cover may be wiped clean with soap and
water.
No other maintenance should be required.
To clean positioning components
Positioning components can be wiped clean with soap
and water.
JAY Zip Back 122962

MAINTENANCE AND CLEANING

CAUTION
• Do not immerse positioning components underwater.
If you have any additional questions regarding cleaning
procedures, please contact your authorized Sunrise
Medical dealer.
HYGIENE MEASURES WHEN BEING RE-USED
Prior to the wheelchair being re-used, it must be carefully
prepared. All surfaces which come into contact with the
user must be treated with a disinfection spray.
To do this, you must use a disinfectant as authorised/
recommended in your country, for rapid alcohol-based
disinfection for medical products and medical devices,
which must be disinfected quickly.
Please be aware of the manufacturer's instructions for
the disinfectant you are using.
In general, a complete disinfection cannot be guaranteed
on seams. We therefore recommend that you dispose
of seat and back slings to avoid micro-bacterial
contamination with active agents according to your local
infection protection law.
CONDITIONS FOR SAFE STORAGE
• Products should be stored in a dry place: at 20 –
75% Relative Humidity.
• Protect from direct sunlight and dust for long periods.
• Away from direct heat and at a temperature between
5°C (40°F) to 40°C (104°F)
• Position and stack the packaged products according
to the "this side up" arrows on the packaging.
• If a package is high and narrow and therefore
potentially unstable, ensure it is well secured on
the pallet or in the racking, to prevent it from falling
down.
• Do not stack anything on top of the packaged
products when the "do not stack" mark on the
packaging is shown.
• Product should never be stored outside and subject
to the elements.
LAUNDRY CARE SYMBOLS
FIG.2.0
6
Machine wash in warm
water (60° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
REV.H