Tools Needed; Items Not Included; Check Direction Of Gate Swing - Nortek Security & Control Mighty Mule MM372W Installation Manual

Drill
Level
● Low voltage wire will be needed to run from the
transformer to the control box; length depends
upon the distance between the transformer power
supply and the control box. See Transformer/Solar
and Battery Power Installation on
the accessory catalog.
● PVC conduit.
● If you have thin-walled tube or panel gates, see
Reinforcing Gates for the Gate Brackets, next
page.
● Depending on the type of gate, a horizontal cross
member or mounting plate may be needed to
mount the front of the operator and gate bracket to
the gate. See the Reinforcing Gates for the Gate
Brackets examples, next page.
xiv
MM371W / MM372W Installation Instructions
7/16" Bit
1/2" Bit
7/32" Bit
Pliers
Clamps

ITEMS NOT INCLUDED

page 16, and

CHECK DIRECTION OF GATE SWING

Your Property
Pull-to-Open Option
Instructions begin on page 2.

TOOLS NEEDED

Pen
Hack Saw
Philips Head
Screwdriver
9/16"
wrench
Adjustable
Wrench
● Surge protection for transformer.
● Some types of installations require u-bolts.
● Additional washers or a metal plate may be
needed for wooden post.
● Weatherproof cover for outdoor outlet and
transformer.
● If the post is larger than 6", bolts longer than 8"
are needed.
(Requires Push-To-Open Bracket
#FM148—NOT INCLUDED)
Your Property
Push-to-Open Option
Instructions begin on page 8.
Center
Punch
1/2"
wrench
Flat Head
Screwdriver
Wire
Small
Stripper
Flat Head
Hammer
Tape
Measure