Checking Oil Level, Topping Up And Changing The Oil - ABAC GENESIS Series Use And Maintenance Handbook

Checking oil level, topping up and changing the oil

Before performing any maintenance operations read the operator safety precautions in
chapter 5 carefully. These precautions must be followed scrupulously for all maintenance
operations
Checking oil level and topping up
Check the level of the oil in the machine circuit frequently when the machine has been stopped for at least
thirty minutes.
This operation is very simple: inspect the oil level on the level reference tube TRL (Fig.41) after disassembling
the front panel PF
The oil level must be visible but must not exceed the RLMAX maximum level reference.
When the level of the lubricant is close to the minimum limit of the level reference tube TRL, top up the oil.
Never let the oil drop to a level which is no longer visible through the reference level tube
TRL!
Maximum level is reached when the oil laps the edge of the maximum level reference RLMAX during top-up
.
Top up when required, as follows:
Remove the front panel PF using the
key provided
Loosen oil filler plug TO. Be careful not
to lose the seal (Fig. 42)
Use a funnel to pour oil into the filler
sleeve (Fig. 42)
Top up the oil level using only the
amount indicated in paragraph 4.7
Avoid too much oil!!! Ensure the
level of the oil does not exceed the
maximum reference level RLM (Fig.
41)
Check that the seal of the plug is cor-
rectly positioned and fasten the plug (not
too tightly)
Replace the front panel PF using the
key provided
Fig. 41
Fig. 42
P. 73 - Chap. 10 Maintenance
10.5
G
B
TRL
RLMAX
RLMIN
TO