Table of Contents
Advertisement
6
Handling instructions
Use a forklift truck to handle the compressor
making sure that the forks are positioned in the
machine base unit supporting feet (Fig. 27).
Lift the machine from the front only both for the
G
basic version and version with receiver.
B
For the machine with 270 lt receiver, the
maximum width of the forks is 540 mm; no
restriction exists for the machine with 500 lt
receiver.
Make sure the load is properly balanced.
Alternatively, a pallet truck can be used for
short distances. Avoid any excess stress on
the metal structure (Fig. 28).
When using a lifting device for handling do
not exert force on the sides of the machine to
prevent damage to the unit and control panel.
Make sure that the load is balanced.
Receivers under pressure, even if small, must never be transported
Installation site requirements
General remarks
The machine should be installed by authorised Service Centre skilled personnel to ensure that machine
installation site is suitable.
The machine is ready to be installed and does not require foundations. Site the compressor on level ground,
in a stable position, with the weight evenly distributed on the supports.
Handling and
installation
Fig. 27
Fig. 28
P. 30 - Chap. 6 Handling and installation
6.1
6.2
- Quick Links:
- Control Panel MC
Hide quick links:
Advertisement
Table of Contents
