Installation Bellfi Res Wi-Fi Box - Bellfires Wi-fi box Manual

Receiver:
Receiver
connection
USB:
Not in use
2.4 INSTALLATION BELLFIRES WI-FI BOX
If the fi re is not fi tted with Wi-Fi control, then the existing receiver can be replaced by a
receiver with Wi-Fi functionality using the instructions below.
The installation of the Wi-Fi box is also described.
In this case the hand transmitter must also be exchanged for a model that is suitable for
communication with the new receiver.
• Disconnect the connected receiver (which can be recognised by the green sticker,
receivers before October 2015 are provided with a silver sticker) and connect the
disconnected cables to the new receiver (with blue sticker).
• Connect the receiver with the Bellfi res Wi-Fi box using the cable supplied. Connect
this cable to the input "SI" on the receiver and the input "Receiver" on the Bellfi res
Wi-Fi box.
• Connect the 6 VDC mains adapter to the receiver.
• As soon as the Bellfi res Wi-Fi box is connected, the LED lights will light up.
10
English
Instructions for use