Basic Configurations; Assigning The Ip Address Automatically; Setting Up Third-Party Ip Cameras - GeoVision GV-NVR System Lite V2 Series Quick Start Manual

5. Basic Configurations

After you have installed the necessary cables and IP cameras, you are ready to access the
channels on GV-NVR System Lite V2. For details, see 3.4 Setting Up IP Cameras in the
GV-NVR System Lite V2 User's Manual.

Assigning the IP Address Automatically

1. Power on the GV-NVR System Lite V2. The GV IP cameras with the default IP address
(192.168.0.10), ID (admin) and password (admin) are detected, this message appears.
2. Click OK. The GV-NVR System Lite V2 will assign unused IP addresses and connect to
each of the GV IP camera in the form of 192.168.X.X. The channel will then be displayed
on the main screen.
Note:
1. You can change the automatically assigned IP address of a GV IP camera. See
Changing the IP address of the GV IP Cameras later in the Quick Start Guide.
2. If you select Cancel for manual IP assignment, see 3.4 Setting Up IP Cameras in the
GV-NVR System Lite V2 User's Manual.

Setting Up Third-Party IP Cameras

1. On the main screen, click the Configure button, select System Configure, and click IP
Camera Install.
2. Click the Scan Camera button.
3. Click the Start Scan button. The IP devices under the same LAN with the GV-NVR
System Lite V2 will be searched and listed.
4. Double-click the IP camera.
5. Type the ID and password of the IP camera and click OK.
10